Whirlpool Washers Error Codes

Excessive suds in washer. Washer is running a suds reduction routine.

Allow the washer to continue. Use only HE detergent. Always follow the detergent manufacturer's instructions to determin...

Excessive suds in washer. Washer is running a suds reduction routine.

Allow the washer to continue. Use only HE detergent. Always follow the detergent manufacturer's instructions to determin...

Water supply error.

Unit will drain for 8 minutes while door remains locked. The drain cycle must be allowed to complete, or the error code...

Water supply error.

Unit will drain for 8 minutes while door remains locked. The drain cycle must be allowed to complete, or the error code...

Drain pump system error.

Check proper inlet hoses. Check plumbing for correct drain hose installation.

Washer door not locking.

Touch POWER to cancel the cycle. Check that the door is closed completely and latching.

Water supply error

Unit will drain for 8 minutes; allow to complete. Check both hoses attached, water flowing to inlet valve, faucets on, i...

Drain pump system error

Use manufacturer's recommended inlet hoses. Ensure top of drain pipe is at least 39" above floor, hose no farther than 4...

Door will not lock

Touch POWER to cancel the cycle. Check that the door is closed completely and latching.

Invalid action performed (e.g., trying to start with door open, selecting different cycle while one is running)

No further action is needed to correct this.

Remove load (load detected in drum during Clean Washer cycle)

Remove items from washer drum and restart Clean Washer with affresh® cycle.

Power failure (appears upon recovery from power loss)

Touch POWER once to clear the code. Then touch POWER again and restart the washer.