Samsung Washers Error Codes

The Water Level sensor is not working properly.

Turn off the washer, unplug it, wait 30 seconds, and then plug the washer in again.

Check the motor for operation.

Try restarting the cycle. If the problem continues, call for service.

Water is not supplied.

Make sure water taps are open. Make sure water hoses are not clogged. Make sure water taps are not frozen.

Cold water supply hose is firmly connected to the hot water tap.

Make sure the cold water supply hose is firmly connected to the cold water tap.

Water is not draining.

Make sure the drain hose is not frozen or clogged. Make sure the drain hose is positioned correctly, depending on the co...

The electronic control needs to be checked (Over Voltage Error).

Check if power is supplied properly. Turn off the washer, unplug it, wait one minute, and then plug the washer in again.

Low voltage detected.

Check if the power cord is plugged in. Turn off the washer, unplug it, wait one minute, and then plug the washer in agai...

Inverter Communication problem.

Turn off the washer, unplug it, wait one minute, and then plug the washer in again.

Operating the washer with the door open.

Make sure the door is properly closed. Make sure laundry is not caught in the door.

High temperature heating check.

Turn off the washer, unplug it, wait one minute, and then plug the washer in again.

Check the drain hose.

Make sure the end of the drain hose is positioned correctly. Make sure the drain hose is not clogged.

Water overflowed.

Restart after spinning. Turn off the washer, unplug it, wait one minute, and then plug the washer in again.

When position of the clutch can't be detected.

Turn off the washer, unplug it, wait one minute, and then plug the washer in again.

After position of the clutch is detected, if the signal from the clutch hall is incorrect.

Turn off the washer, unplug it, wait one minute, and then plug the washer in again.

Spinning does not work.

Make sure laundry is spread out evenly. Make sure the washing machine is on a flat, stable surface.

Display for additional rinsing. Appears when additional rinsing cycle senses that tub is unbalanced.

Press any button/key to release the display.

Check the MEMS sensor.

Power the washer off. Wait 2-3 minutes, power the washer on, and then try again.

Firmware update is in progress through SmartThings.

To use the product, wait about 30 minutes until the firmware update completes.

Water level is above safe level and Child Lock is on while lid is open.

Washer drains water by force. To cancel 'CL' mode, turn power off and then on again.