Samsung Appliance Accessories Error Codes

Vent condition is good.

N/A

The vent is clogged (about 80% clogged, may decrease drying performance).

1. Clean the lint filter. 2. Check your vent condition (refer to "Ducting requirements" section). 3.

About 80% of the vent is clogged (may decrease drying performance).

1. Clean the lint filter. 2. Check your vent condition (refer to "Ducting requirements" section). 3.

Over 90% of the vent is clogged (may lead to poor drying performance or cause malfunction).

1. Clean the lint filter. 2. Check your vent condition (refer to "Ducting requirements" section). 3.

The internal temperature of the dryer is too low (below 32 °F (0 °C)) or too high (over 104 °F (40 °C)) and therefore vent blockage cannot be detected.

Leave the dryer at room temperature (41~95 °F (5~35 °C)) for an hour and check again.

Temperature sensor error / The Thermistor1 resistance is very low or high.

Contact a service center. / Check for a clogged lint screen. Check if the vent system is restricted.

Unit is detecting items inside the drum or there is an error on the dry sensor.

Remove items from the drum and check again. If the problem continues, contact a service center.

Unit is detecting door is open / Operating the dryer with the door open.

Close the door properly and check again. Make sure laundry is not caught in the door.

Abnormal voltage detected / The electronic control needs to be checked.

Check the power connection (refer to "Connect the electrical wiring" section). Check if power is supplied properly.

Invalid power source frequency.

Try restarting the cycle. If this information code remains, contact a Samsung service center.

Electronic control problem (Invalid Communication).

Contact a Samsung service center.

The Thermistor2 resistance is very low or high.

Check for a clogged lint screen. Check if the vent system is restricted.

Incorrect door switch.

Contact a Samsung service center.

The PBA needs to be checked.

Unplug the power plug and contact a Samsung service center.

High temperature heating check

Clean the lint filter. If this information code remains, contact a Samsung service center. (enter the line test mode)